Wine Bottle Caps Precision Mould

Company advantage：

Hongke mold specializes in cap mold making and injection molding, with 16 years of experience in injection mould.

Hongke focuses on creating diversified wine drinks cap injection mould and drinks Caps moulding for customers, the company pays attention to the production quality of Wine bottle plastic bottle cap, and meets the diversified needs of customers.

Production quality：

Wine bottle plastic bottle caps produced by Hongke mold are well sealed and can prevent leakage, volatilization or oxidation of the liquid inside the bottle, thus extending the shelf life of the product. At the same time, plastic bottle caps can be made in different ways to meet different sealing needs, and also improve the quality and reliability of the packaging.

Plastic PP material advantages：

Properties: tasteless, odorless, non-toxic, dull surface, milky waxy particles, density of about 0.920 g/cm3, melting point 108℃ ~ 126℃. Insoluble in water, slightly soluble in hydrocarbons, etc. Resistant to most acid and base erosion, water absorption is small, can still maintain softness at low temperature, high electrical insulation.

Environmentally friendly plastic：

Compared to other practical bottle caps, wine bottle plastic bottle caps are easy to recycle and use. Due to the sustainable use of plastic materials, it will not cause pollution to the environment and landfills when recycling and recycling plasticity. Therefore, it is an environmentally friendly bottle cap, and many brands have also adopted this eco-friendly bottle cap in line with consumer values.

Runner characteristic:

1. Increase the quality of injection molding products

The hot runner mold uses the hot runner system to directly transport the plastic material to the center of the mold, which can effectively avoid the cold material phenomenon in the injection process, thereby increasing the quality of the injection product.

2. Save raw materials

The hot runner mold can effectively avoid the generation of cold material, so the use of raw materials can be saved, and the production cost can be reduced.